Peterbilt Conventional Truck Series — Vehicle Recovery Guidelines

VEHICLE RECOVERY AND SPRING BRAKES This action will lock the differential by pushing a piston into a “lock” position. Failure to lift the driving wheels off the ground or remove the driveline and axle shafts before towing the ve- hicle could seriously damage your vehicle. All lubricating and clutch ap- plication oil pressure is provided by an engine-driven pump, which does not work when the engine is stopped. When vehicles are towed either by wrecker or piggyback, lubricant in the top front of the drive axle will drain to the rear. This will leave the top com- ponents dry, resulting in friction that will seriously damage these compo- nents.

CAUTION Water, dirt and other material can enter an open hub or axle. This can contaminate the axle fluid and cause possible damage to compo- nents. Ensure that the hubs are cov- ered with plastic whenever a drive axle shaft is removed. CAUTION CAUTION Failure to install the caging bolt when towing vehicles with driver-control main differential lock can result in damage by failing to lock internal components in position. 2 3. For vehicles with driver-controlled main differential lock, install the caging bolt before removing the axle shafts for towing. WARNING! a. Remove the air line and firmly cap.

Ensure there are no open air lines on the recovered vehicle if the re- covery vehicle and recovered vehicle brake systems are connected. An open air line on the recovered vehi- cle will cause a leak in the air brake system of the recovery vehicle pos- sibly causing death, personal injury, equipment or property damage. 2. Cover open hubs when removing drive axle shafts. b. Remove the caging bolt from its storage hole. c. Screw the caging bolt into the air line hole. When fully engaged, a 0.25-0.5 in. (6.35-12.7 mm) space will remain between the air cylinder and the bolt head. (03/17) Y53-6076-1B1 2-19