Komatsu — 30.1 GENERAL LOCATIONS

30. MACHINES READY FOR ATTACHMENT 30. MACHINES READY FOR ATTACHMENT 3. CONTROL PEDAL This is used to operate the attachment. The pedal can be depressed to the front, neutral, and rear to operate the attachment as follows. N Hydraulic breaker Front of pedal 1 : Actuate Pedal neutral N : Stop Rear of pedal 2 : Stop For use of the pedals with other attachments, consult with the attachment manufacturer at the time of installation to determine the operation of the attachment and pedals. AM092030 4. LOCK PIN This locks the control pedal. Position 1 : Lock Position 2 : Pedal half-stroke position (oil flow 50%) Position 3 :

Pedal full-stroke position (oil flow 100%) When using the breaker, select the breaker mode on the monitor, and use position 3 . The oil flow at position 2 is smaller, so select it when using other attachments. Keep the lock pin in the LOCK position except when using the attachment. AM092040 5. ADDITIONAL FILTER FOR BREAKER This is used to prevent deterioration of the hydraulic oil when using the breaker. The oil flows through this only when the selector valve is at the breaker position. AM092050 6. ACCUMULATOR (FOR CONTROL CIRCUIT) WARNING The accumulator is charged with high-pressure nitrogen gas, and it is extremely dangerous if it is handled mistakenly.

For details of handling, see “11.19 HANDLING ACCUMULA- TOR”. This is installed to release any remaining pressure in the attach- ment circuit after the engine is stopped. Normally, do not touch it. AM090140 5-10