Operator Cab and Controls - Section 32 08/11 OM3206 Page 32-4 ACCELERATOR (THROTTLE) PEDAL Accelerator (throttle) pedal (4, Figure 32-1) is a foot- operated pedal which allows the operator to control engine rpm, depending on pedal depression. HEATER / AIR CONDITIONER COMPART- MENT AND CONTROLS The heater/air conditioner compartment contains heater/air conditioner controls (6, Figure 32-1) and some of the heater/air conditioner components, such as the blower motor assembly and the heater coils. Optimum cab air climate can be selected by using the following controls in various combinations.
Defroster Vent Control Switch Defroster control switch (1, Fig- ure 32-3) directs heated air for windshield defrosting. The down- ward position of the rocker switch is OFF. The upward position of the rocker switch is ON. The foot-operated treadle pedal contains an elec- tronic sensor which sends signals to the Quantum™ fuel control system. The movement of the fuel gover- nor control arm corresponds directly to the travel of the treadle pedal as it is applied by the operator. When the pedal is released, springs return the con- trol arm and the pedal to their "rest" positions and the engine speed returns to low idle.
Outside/Inside Air Control Switch Outside/inside air control switch (2, Figure 32-3) allows either out- side or inside air to be circulated through the cab heater assembly. Moving the switch upward directs inside air to be recirculated through the heater assembly. Moving the switch downward directs outside air to be circu- lated through the heater assem- bly and into the cab. INSTRUMENT PANEL Instrument panel (5, Figure 32-1) includes a center electronic display panel, and L.H & RH panels/pods which contain a variety of switches and indicators.
Refer to Instrument Panel and Indicator Lights later in this section for a detailed description of the func- tion and location of each of these components. Heat Vent Control Switch Heater control (3, Figure 32-3) directs heated air to the cab floor for heating of the cab. The down- ward position of the rocker switch is OFF. The upward position of the rocker switch is ON. Fan Control Knob Fan control knob (4, Figure 32-3) is provided to control the cab air fan motor. The fan motor is a 3- speed motor (low, medium and high). Speeds are selected by rotating the control knob clock- wise to the desired position. OFF is in the full counter-clockwise position.