OM3206 08/11 Operator Cab and Controls - Section 32 Page 32-5 Temperature Control Knob Temperature control knob (5, Figure 32-3) allows the operator to select a comfortable temperature. Rotating the knob counter-clockwise (blue arrow) will select cooler temperatures. Full counter-clockwise position is the coldest air setting. Rotating the knob clockwise (red arrow) will select warmer temperatures. The full clockwise position is the warmest heater setting. Heater/air conditioner vents (7, Figure 32-3) may be rotated 360°.
There are three vents in the heater/air conditioner compartment (shown in Figure 32-3), four vents across the top of the panel, and one vent each in the RH and LH instrument panel pods. Air flow through the vents is controlled by manually opening, closing or turning the louvers. Heater/Air Conditioner Vents Air Conditioner Control Switch RETARDING CAPACITY CHART Air Conditioner control switch (6, Figure 32-3) is a three position switch that controls the air condi- tioner to cool the cab air. Moving the switch to the left activates the air conditioner. When the switch is in the center position, the air conditioner and the heater are both activated.
When the switch is moved to the right side, only the heater is activated. Retarding capacity chart (8, Figure 32-1 & shown below) provides the recommended maximum truck speeds for descending various grades with a fully loaded truck. The operator should reference the retarding capacity chart before descending any grade with a loaded truck. Proper selection of road grade, truck speed, transmission gear range, and use of the retarder lever and/or brake pedal are required to maintain a safe speed. Customer specified options may cause this decal to change: Always refer to the retarding capacity chart in the operator's cab, and follow the recommenda- tions there for safe truck operation.
DO NOT exceed these recommended maximum speeds when descending grades with a loaded truck. Refer to Operating Instructions, Retarder Operation, for more information on using the retarder function. FIGURE 3-3. A/C & HEATER CONTROLS