FUEL SYSTEM - DISASSEMBLY, INSPECTION AND REASSEMBLY 1. Fuel Injection Nozzles 1.1 Disassembling the fuel injection nozzles Replace: Gasket Wear Fatigue, Perpendicularity Wear, Damage Carbon deposit, Clogged nozzle hole Disassembly of the fuel injection nozzle ① Nozzle retaining nut ② Nozzle tip assembly ③ Piece ⑦ Nozzle holder ⑧ Gasket 1.2 Inspecting the fuel injection nozzle Conduct the following inspections and, if faulty, repair or replace as required. (1) Injection valve opening pressure (a) Install the fuel injection nozzle onto the nozzle tester. Pump the tester handle up and down to bleed air. (b) Pump the tester handle at a rate of approx.
one cycle per second while observing the needle of the tester. Note: The needle should rise slowly and, during fuel injection, should vibrate. The pressure at which the needle starts to vibrate is the injection valve opening pressure. ④ Pin ⑤ Spring ⑥ Washer Nozzle tester Inspecting the injection valve opening pressure 3 - 10