FUEL SYSTEM - DISASSEMBLY, INSPECTION AND REASSEMBLY (c) If the measured pressure does not conform to the standard value, disassemble and adjust by changing the thickness of the washer. Unit: MPa (kgf/cm 2 ) [psi] Nozzle tip end (d) Change in washer thickness by 0.1 mm (0.004 in.) results in a pressure change of 1.0 MPa (10 kgf/cm 2 ) [145 psi]. Washers are available in 10 different thicknesses at intervals of 0.05 mm (0.002 in.) in the range between 1.25 and 1.70 mm (0.049 and 0.067 in.). Replacing the fuel injection nozzle tip assembly Never touch the spray of fuel from the fuel injection nozzle.
(2) Inspecting the fuel spray pattern from the fuel injection nozzle (a) When inspecting the injection valve opening pressure using the nozzle tester, also check for such as clogged nozzle hole, fuel spray pattern and fuel leakage from the nozzle hole. (b) When the tester handle is pumped at a rate of approx. one cycle per second, fuel should be sprayed in a fairly straight pattern. (3) Clean or replace when spraying badly (a) Loosen the nozzle retaining nut to remove the nozzle tip assembly. Clean the needle valve and the nozzle tip body.
Good Bad (Diffused) Bad (Dribbling) Bad (Feathering) Bad (Deflected) Fuel spray patterns When removing the nozzle tip assembly, never tap on the end of the assembly. Needle valve Nozzle tip body (b) Wash the needle valve and the nozzle tip body in clean wash oil. Reassemble them in clean light oil. Note: The needle valve and the nozzle tip body are precision machined parts. Handle with care and never change their combination. Cleaning the fuel injection nozzle tip components 3 - 11 Standard value Injection valve opening pressure 14.22 to 15.00 (145 to 153) [2062 to 2176]