ELECTRICAL SYSTEM - DISASSEMBLY, INSPECTION AND REASSEMBLY (3) Adjusting the pinion shaft end play Adjust the end play (thrust gap) to 0.5 mm (0.02 in.) or less as illustrated by inserting an appropriate washer between the center bracket and the reduction gear. (a) Install the pinion shaft complete with reduction gear washers and a snap ring onto the center bracket. (b) Measure the pinion shaft end play by moving the shaft in the axial direction. If the measured value exceeds 0.5 mm (0.02 in.), correct by adding adjusting washers. (4) Installing the lever Install the lever in the correct orientation.
(5) Inspecting the pinion gap With the pinion fully pulled out to the rear, gently push back the end of the pinion with a finger and measure the distance that the pinion has moved back. If the measured distance is out of the 0.5 to 2.0 mm (0.02 to 0.08 in.) range, add or reduce the packings mounted at the magnetic switch. If the pinion gap is too great, add the packings. If the pinion gap is too small, reduce the packings. Reduction gear Adjusting washer Washer Snap ring Max. 0.5 mm (0.02 in.) End play Adjusting the pinion shaft end play Front bracket Lever Lever spring Packing Installing the lever Pinion Gently push back.
Pinion gap 0.5 to 2.0 mm (0.02 to 0.08 in.) Adjusting the pinion gap 7 - 17