ELECTRICAL SYSTEM - DISASSEMBLY, INSPECTION AND REASSEMBLY 1.3 Reassembling the starter Reassembly follows the disassembly procedures in reverse while observing the following. (1) Lubrication When the starter is overhauled, apply grease to the following sliding surfaces, gears and bearings.
M008T70471A, M008T81071A Apply grease to the contact faces of the overrunning clutch and the lever Grease Multemp PS2 (KYODO YUSHI CO.,LTD) or equivalent (a) Armature shaft gear, reduction gears (b) Bearings (c) Pinion shaft washer and stopper ring (d) Pinion (e) Lever’s sliding surfaces M001T68281 Ensure that the starter mounting face, the brushes, the commutator and other current-carrying parts are not smeared with grease. (2) Installing the stopper ring Install a new stopper ring into the ring groove on the pinion shaft. Using a puller, pull the pinion stopper until its groove engages with the stopper ring. Note: On reassembly, use a new stopper ring.
Apply MOLYKOTE RAG650 to locations marked with * Grease points Pinion stopper Pinion stopper Stopper ring Installing the stopper ring 7 - 16