ELECTRICAL SYSTEM - DISASSEMBLY, INSPECTION AND REASSEMBLY (6) Inspecting the overrunning clutch (a) The shaft should rotate smoothly in one direction, but should not rotate in the opposite direction. (b) Check the pinion for wear or damage. If faulty, replace. Do not wash the overrunning clutch in wash oil. (7) Front bracket The ball bearing should rotate smoothly without abnormal noise. If faulty, replace the entire front bracket. (8) Internal gear, planetary gears, and armature shaft gear Replace if worn or damaged. (9) Lever As the lever’s friction surface with the overrunning clutch wears, the pinion gap goes out of the standard value. If so, adjust or replace the lever.
(10) Magnet switch Measure between M terminal and the body. If no continuity is indicated, replace the magnet switch. Measure between B and M terminals. If continuity is indicated, replace the magnet switch. Inspecting the overrunning clutch S terminal M terminal B terminal Inspecting the magnet switch 7 - 15