ELECTRICAL SYSTEM - DISASSEMBLY, INSPECTION AND REASSEMBLY (c) Push a new brush into the brush holder before soldering the brush lead. 2.3 Reassembling the alternator To reassembly, follows the disassembly sequence in reverse and do the following steps. (a) The rear bearing has an eccentric groove around the periphery. The deepest portion of this groove should be aligned with the lug on the snap ring. (b) When replacing the rear bearing, a new bearing should be press-fitted so that the groove on its periphery is placed to the slip ring side. (c) Heat the rear bracket before press-fitting the rear bearing into the bracket.
(d) When installing the rotor into the rear bracket, insert a wire through a small hole in the bracket to lift the brushes. After installation, remove the wire. Installing a new brush Wire Rear bracket Brush Wire Reassembling the alternator 7 - 22