Mitsubishi — Mitsubishi Diesel Engine Service Manual

ENGINE - INSPECTION / ADJUSTMENT, RUNNING-IN TRIAL AND PERFORMANCE TEST 1. Inspection and Adjustment of Engine 1.1 Preparations for valve clearance inspection and adjustment (1) Inspection and adjustment of valve clearance should be performed when the engine is cold. (2) Slightly loosen the cylinder head bolts. Then, tighten them to the specified torque in the order illustrated. 1.2 Inspecting the valve clearance (1) Move the piston of the No. 1 cylinder to the top dead center of the compression stroke. This is achieved by aligning the TDC mark on the crankshaft pulley with the counter mark on the gear case. (2) To verify that the No.

1 piston is at the top dead center of the compression stroke, rotate the crankshaft approx. 20є in both forward and reverse directions. If the relevant rocker arm does not move while rotating the crankshaft, the No. 1 piston is at the top dead center of the compression stroke. (3) If the rocker arm moves, the piston of the No. 1 cylinder is at the exhaust top dead center. Try again to set the No. 1 piston at the top dead center of the compression stroke by rotating the crankshaft one more turn. (4) Starting with the No. 1 cylinder and moving to other cylinders in the firing order, inspect and adjust the valve clearance. With the valve clearance for the No.

1 cylinder adjusted, set the piston of the next cylinder in the firing order to the top dead center of the compression stroke. To do this, rotate the crankshaft in the forward direction (clockwise when facing the timing gear case) by 180є. 5 10 4 2 7 S4L,S4L2 8 13 11 12 14 1 9 6 3 Front of engine Tightening torque: 83.4 to 93.2 N m (8.5 to 9.5 kgf m) [61.5 to 68.7 lbf ft] 8 2 4 7 9 6 3 5 10 11 1 S3L,S3L2 Tightening order for the cylinder head bolts TDC mark for No. 1 and No. 4 pistons Counter mark on gear case IT mark TDC mark for No. 2 and No. 3 pistons Timing marks 8 - 2 Firing order (Cylinder No.) Crankshaft rotation angle 1-3-2 240º 1-3-4-2 180º