ENGINE - INSPECTION / ADJUSTMENT, RUNNING-IN TRIAL AND PERFORMANCE TEST (3) Clean or replace when spraying badly (a) Loosen the nozzle retaining nut and remove the nozzle tip assembly. Clean the needle valve and the nozzle tip body. When removing the nozzle tip assembly, never tap on the end of the assembly. Needle valve Nozzle tip body (b) Wash the needle valve and the nozzle tip body in clean wash oil. Reassemble them in clean light oil. Note: The needle valve and the nozzle tip body are precision machined parts. Handle with care and never change their combination. (c) Assemble the fuel injection nozzle, tightening the nozzle retaining nut to the specified torque.
(d) If the fuel spray pattern is still not good, replace the nozzle tip assembly. Note: (a) Never touch the sliding surface of the needle valve with your hands. (b) If the nozzle tip assembly is replaced, remove the seal peel (synthetic resin film) from the new nozzle tip assembly and slide the nozzle and needle valve in clean wash oil to completely remove the anti-corrosive agent. (4) Installing the fuel injection nozzles (a) Install a new gasket onto the fuel injection. (b) Insert the fuel injection nozzle into the cylinder head, and tighten to the specified torque. Cleaning the fuel injection nozzle tip components Tightening torque:
34.3 to 39.2 N m (3.5 to 4.0 kgf m) [25.3 to 28.9 lbf ft] Tightening the retaining nut Replace: Gasket Tightening torque: 49.0 to 58.8 N 㨯 m (5.0 to 6.0 kgf 㨯 m) [36.2 to 43.4 lbf 㨯 ft] Installing the fuel injection nozzle 8 - 10