ENGINE - INSPECTION / ADJUSTMENT, RUNNING-IN TRIAL AND PERFORMANCE TEST 3. Performance Test While a number of methods exist for testing the performance of engines, the following are excerpts from “Earth-moving machinery - Engines - Part 1: Test code of net power (JIS D0006-1)” and “Earth-moving machinery - Engines - Part 2: Standard format of specifications and tests methods of diesel engines (JIS D0006-2).” Test items will need to be expanded in a manner appropriate for specific applications. The performance of the engine should be determined based on the overall test results.
3.1 Standard ancillaries The engine being tested should be equipped with those ancillaries that are essential for the engine to operate normally, including the radiator fan, air cleaner, and alternator. 3.2 Test items and purposes (1) Working load test This test is aimed at obtaining the output, torque, fuel consumption, and governor performance under various loading.
(2) Continuous load test This test, in which the engine is run continuously for 10 hours under a 90% (continuous) load at the engine speed achieving the nominal net brake power, is aimed at obtaining the fuel consumption and other operating conditions, as well as determining as to whether or not the engine can withstand continuous operation. (3) No-load minimum speed test This test is aimed at confirming as to whether or not the engine can run stably at the specified speed under no load. 3.3 Other tests Check for and correct any leakage of exhaust gas, coolant or oil, abnormal odor, hunting, etc.
3.4 Adjusting the engine power Engine power can be affected by the atmospheric pressure, temperature and humidity. The power of the engine being tested should be adjusted for normal atmospheric conditions. (1) Normal atmospheric conditions are: Reference temperature: 298 K [25 (77 ° F )] Atmospheric total pressure: 100 kPa (750 mmHg) Reference dry atmospheric pressure : 99 kPa (743 mmHg) (2) Correcting the engine output Measured brake power and torque should be corrected by multiplying them by the diesel engine correction coefficient described below. Corrected output = correction coefficient ( α c ) Ч measured brake output Atmospheric conditions for testing Temperature(T):
283 K [10 (50 ° F )] T 313 K [40 (104 ° F )] Dry atmospheric pressure: 80 kPa (600 mmHg) P 110 kPa (825 mmHg) (3) Calculating the correction coefficient α c =( fa ) fm fa : Atmospheric coefficient fm : Engine coefficient (a) Calculating the atmospheric coefficient ① Engine with no charger, or engine with mechanical supercharger 298 99 = T Pd fa 7.0 ② Turbo-charged engine with no charge cooler, or turbo-charged engine with air-to-air charge cooler 298 99 = T Pd fa 2.1 ③ Turbo-charged engine with water-to-air charge cooler 298 99 = T Pd fa 7.0 7.0 (b) Calculating the engine coefficient( fm ) fm =0.036 qc -1.14 qc :
Corrected fuel delivery rate ① r q qc = q = ( z ) Ч (Fuel flow rate g/s ) (Cylinder capacity l ) Ч (Engine speed min -1 ) z =120000(4-cycle engine) r : Ratio of the outlet pressure of supercharger or charge cooler to the atmospheric pressure ( r = 1 on non-charged engine) 8 - 13