ENGINE - INSPECTION / ADJUSTMENT, RUNNING-IN TRIAL AND PERFORMANCE TEST 2. Running-in Trial Whenever the engine is reassembled after overhaul, run in the engine on a dynamometer. While the engine is being run-in, also perform the inspections listed below. 2.1 Starting the engine (1) Before starting the engine, check the levels of coolant, engine oil and fuel. Also, bleed the fuel and cooling systems of air. (2) With fuel shut off, operate the starter for approx. 10 seconds to crank the engine in order to distribute oil throughout the engine. (3) Move the control lever slightly in the direction of increased fuel delivery (moving the lever to the full delivery position is not recommended).
Turn the starter key switch to the START position to start the engine. (4) With the engine started, move the control lever to the no-load, low idle position. 2.2 Inspecting the engine during running-in While the engine is being run-in, check the followings. If faulty, stop the engine. Locate the cause and take appropriate actions to eliminate it. (1) Oil pressure at the rated and low idle speeds The oil pressure should be 0.29 to 0.39 MPa (3.0 to 4.0 kgf/cm 2 ) [42.07 to 56.57 psi] at the rated speed, and 0.098 MPa (1.0 kgf/cm 2 ) [14.22 psi] or above at the low idle speed. (2) The coolant temperature, which should be 75 to 85 (167 to 185 ° F ).
(3) The temperature of engine oil in the oil pan, which should be 60 to 95 (140 to 194 ° F ). (4) There should be no leakages of oil, coolant or fuel. Pay particular attention to the turbocharger lubrication oil pipe connections. (5) Diesel knock should disappear as the coolant temperature rises. Other than that, there should be no noise. (6) The exhaust gas for any abnormal color or smell. 2.3 Running-in timetable The following table shows the running-in phases together with the relevant load and time duration for each phase.
Running-in timetable 2.4 Inspection and adjustment after running-in (a) Adjust the valve clearance (b) Inspect the fuel injection timing (c) Check the external bolts and nuts for tightness 8 - 12 Engine speed Load (PS) Time (min) 1 2 3 4 5 6 Idle speed 1200 Rated speed (varies depending on engine specifications) No load No load 25 % 50 % 75 % 100 % 5 10 10 10 30 20