Mitsubishi — Mitsubishi Diesel Engine Service Manual

SERVICE STANDARDS Unit:

mm (in.) 1 - 15 Group Item Nominal value Standard value Limit Remarks Inlet and exhaust systems Paper-element type air cleaner Clean every 100 hours Replace every 500 hours Inlet / exhaust manifold mounting face distortion ― 0.15 (0.006) or less Grind or replace Electrical system Starter Pinion gap 0.5 to 2.0 (0.02 to 0.08) ― Adjust with packing No-load character- istics Terminal voltage M001T68281 M008T70471A M008T81071A ― Inspect 11 V 11 V 23 V Current 110 A or less 130 A or less 80 A or less ― Rotation speed 2400 min-1 3600 min-1 3000 min-1 ― Brush length 16.5 (0.65) 18.0 (0.71) M001T68281 M008T70471A, M008T81071A Replace 10.0 (0.39) 11.0 (0.43) Brush spring load 17.5 to 23.7 N (1.78 to 2.41 kgf) [3.9 to 5.3 lbf] 29.4 to 39.2 N (3.0 to 4.0 kgf) [6.6 to 8.8 lbf] 6.90 N (0.70 kgf) [1.6 lbf] 13.7 N (1.40 kgf) [3.1 lbf] Replace Commutator radial runout 0.05 (0.002) 0.03 (0.001) 0.10 (0.004) Correct or replace Commutator diameter 29.4 (1.16) 32.0 (1.26) 28.8 (1.13) 31.4 (1.24) Replace Mica undercutting depth 0.5 (0.02) 0.2 (0.01) Correct Alternator IC regulator controlled voltage [at 20℃ (68°F)] A007T02071C A007TA8571 ― 14.7±0.3 V 28.5±0.5 V Output characteristics (when hot) 2500 min-1 or less Terminal 13.5 V 27.0 V ― voltage Current 32 A or above 18 A or above ― 5000 min-1 or less Terminal 13.5 V 27.0 V ― voltage Current 47 A or above 22 A or above ― Brush length 18.5 (0.73) 5.0 (0.20) Replace Clearance between stop solenoid plunger and rack 0.15 to 0.20 (0.006 to 0.008) Correct Glow plug resistance 0.55 Ω ― Replace