ENGINE MAIN PARTS - DISASSEMBLY 1.4 Removing the cylinder head assembly Remove the cylinder head assembly by lifting it straight up. Note: If the bonding of the cylinder head gasket prevents the head assembly from being separated from the cylinder block, tap the cylinder head side face on a relatively thick portion with a plastic hammer. 1.5 Removing the valves and valve springs (1) Remove the valve caps and locks by compressing the springs using a valve lifter. (2) Remove the retainers, valve springs and valves. Note: If the valves are reusable, mark them so that they can be reassembled back onto their original locations.
This will ensure that the mated pairs of valves and their seats are maintained. 1.6 Removing the valve stem seals Remove the valve stem seals by holding each of them with a pair of pliers. Note: Replace the old valve stem seals with new parts upon reassembly. Removing the cylinder head assembly Removing the valve spring Removing the valve stem seal 2 - 4