Mitsubishi — Mitsubishi Diesel Engine Service Manual

ENGINE MAIN PARTS - DISASSEMBLY 2.1 Removing the flywheel (1) Have an assistant lock the flywheel pulley using a wrench or other similar tool to prevent the flywheel from rotating. (2) Remove one of the flywheel retaining bolts. The person who locks the crankshaft pulley should do so with extreme care. Each worker should pay attention to the safety of the other. Locking the flywheel with a wrench etc. Locking the flywheel (3) Install a safety stud (M12 Ч 1.25) into the hole from which the retaining bolt has just been removed. With the stud installed, remove the remaining flywheel retaining bolts.

(4) While holding the flywheel with both hands, rock the flywheel towards you and away to pull it out straight towards you. Safety stud (a) When pulling off the flywheel, be careful not to cut your hands with the ring gear. (b) Be careful not to damage the flywheel by dropping it or bumping it against hard objects. (c) The ring gear has been shrink-fit onto the flywheel. Do not attempt to remove the ring gear unless it is faulty. Removing the flywheel 2.2 Removing the flywheel housing Remove the flywheel housing retaining bolts. Remove the flywheel housing. Removing the flywheel housing 2 - 7