Mitsubishi — Mitsubishi Diesel Engine Service Manual

ENGINE MAIN PARTS - DISASSEMBLY 2.3 Removing the rear plate The rear plate has been located into position with knock pins. Therefore, the plate needs to be removed by pulling it straight towards you. 2.4 Removing the oil seal case Remove the oil seal case retaining bolts. Then, ply away the case from the cylinder block using a screwdriver or other similar tool. Removing the rear plate When removing the oil seal case, be careful not to damage the oil seal. 2.5 Removing the tappets While holding the push rods, remove the tappets from the cylinder block. Note: The camshaft should not be removed before removing the tappets. Otherwise, the tappets will drop into the oil pan.

2.6 Removing the crankshaft pulley (1) Lock the crankshaft so that it will not rotate. To rock the camshaft, install two safety studs (M12 Ч 1.25) into the threaded holes at the rear end of the crankshaft and then place a bar between the studs. (2) Remove the crankshaft pulley. Removing the oil seal case Tappet Push rod Removing the tappet Lock the crankshaft. Crankshaft pulley While trying to remove the crankshaft pulley, the bar may dislodge from the studs. Pay sufficient attention to ensure safety. Removing the crankshaft pulley 2 - 8