ENGINE MAIN PARTS - DISASSEMBLY 3.4 Removing the pistons (1) Rotate the crankshaft to place the piston being removed at the top dead center. (2) Using a wooden piece such as the stem of a hammer, push the piston and connecting rod assembly on the mating face with the connecting rod cap to remove the assembly from the cylinder block. 3.5 Measuring the crankshaft end play With a dial gauge installed onto the end of the crankshaft, measure the shaft end play. If the measured value exceeds the limit, replace the flanged No. 3 bearing. Unit: mm (in.) 3.6 Removing the main bearing caps (1) Place the engine so that the cylinder block mating surface with the oil pan faces upwards.
(2) Loosen the main bearing cap bolts. Then, remove the caps. (3) On the front and rear main bearing caps, remove these using a sliding hammer. 3.7 Removing the crankshaft (1) Remove the crankshaft by slowly lifting it straight up. Removing the piston Measuring the crankshaft end play Removing the main bearing cap When lifting the crankshaft, take care not to damage the main bearings. (2) The main bearings may fall down, making it not possible to identify their original locations. Once the crankshaft is removed, place the main bearings neatly and in the original pairs so that they can be reassembled back onto their original locations.
Removing the crankshaft 2 - 14 Standard value Limit Crankshaft end play 0.050 to 0.175 (0.0020 to 0.0069) 0.500 (0.0197)