ENGINE MAIN PARTS - INSPECTION AND CORRECTION 1. Cylinder Head, Valve Mechanism 1.1 Measuring the cylinder head bottom face distortion Using a straight edge across the bottom face of the cylinder head and a thickness gauge, measure for any distortion. If the measured distortion exceeds the limit, correct with a surface grinder. Unit: mm (in.) 1.2 Measuring the rocker arm bore and the rocker shaft diameter Measure the rocker arm bore and the rocker shaft diameter to obtain the arm-to-shaft clearance. If the clearance is between the standard value and the limit, replace the rocker arm. If the clearance is equal to or exceeds the limit, replace both the rocker arm and shaft. Unit:
mm (in.) Measuring locations and directions Measuring the cylinder head bottom face for distortion Measuring direction Measuring location Measuring direction Measuring the rocker arm inner diameter and the rocker shaft diameter 1.3 Measuring the valve spring for squareness and free length Measure the valve spring for squareness, free length, etc. If any of the measured values exceeds the limit, replace the spring. Unit:
mm (in.) Spring squareness (gap) Free length Measuring the spring for squareness and free length 2 - 18 Standard value Limit Cylinder head bottom face distortion 0.05 less (0.002 less) 0.10 (0.004) Nominal value Standard value Limit Rocker arm inner diameter φ19 (0.749) 18.910 to 18.930 (0.7450 to 0.7458) ― Rocker shaft diameter φ19 (0.749) 18.880 to 18.898 (0.7438 to 0.7445) ― Arm-to-shaft clearance ― 0.012 to 0.050 (0.0005 to 0.002) 0.200 (0.0079) Standard value Limit Free length 47 (1.85) 46 (1.81) Squareness θ θ=2.0º or less △(gap)=0.2 (0.0079) or less Lf=47 (1.8504) △=0.5 (0.0197) across the entire length Installed length/load mm (in.)/N (kgf) [lbf] 39.0 (1.536)/ 131 to 145 (13.3 to 14.7) [29 to 33] 30.1 (1.185)/ 279 to 309 (28.5 to 31.5) [63 to 69] -15%