Mitsubishi — Mitsubishi Diesel Engine Service Manual

ENGINE MAIN PARTS - INSPECTION AND CORRECTION 1.4 Measuring the push rod for bend If the measured value exceeds the limit, replace the push rod. Unit: mm (in.) Note: Use a dial gauge to measure the push rod for bend. 1.5 Measuring the valve stem diameter Measure the valve stem diameter. If the measured value is less than the limit, replace with a new part. Replace also when the valve stem has excessively uneven wear. Unit: mm (in.) Push rod Measuring the push rod bend Measuring direction Measuring location Measuring the valve stem diameter 1.6 Measuring the clearance between the valve stem and guide Measure the valve guide inner diameter using an inside micrometer.

The valve guide wears at the top and bottom ends. Therefore, both ends need to be measured orthogonally. If the measured value exceeds the limit, replace with a new part. Unit: mm (in.) Inside micrometer Measuring direction Measuring location Measuring the valve guide inner diameter Note: Before measuring the valve stem-to-guide clearance, remove carbon from the valve and the valve guide.

2 - 19 Limit Push rod bend 0.3 (0.012) 1/2 1/2 Nominal value Standard value Limit Valve stem diameter Inlet φ6.6 (0.260) 6.565 to 6.580 (0.2586 to 0.2592) 6.500 (0.256) Exhaust φ6.6 (0.260) 6.530 to 6.550 (0.2572 to 0.2580) 6.500 (0.256) Nominal value Standard value Limit Valve stem -to-guide clearance Inlet ― 0.020 to 0.050 (0.0008 to 0.002) 0.100 (0.004) Exhaust ― 0.050 to 0.085 (0.002 to 0.003) 0.150 (0.006) Installed valve guide protrusion 10 (0.394) 9.5 to 10.5 (0.3743 to 0.4137) ―