ENGINE MAIN PARTS - INSPECTION AND CORRECTION 1.7 Replacing the valve guide (1) Using a punching tool, remove the valve guide from the bottom to the top of the cylinder head. (2) Using a press, insert a new valve guide from the top of the cylinder head so that the valve guide protrusion above the cylinder head face is to the indicated dimension. (3) With the valve guide press-fit into position, insert a new valve to verify that it slides smoothly inside the valve guide. (4) Check the valve face-to-seat contact. 1.8 Inspecting the valve face (1) Apply a thin coating of red lead onto the valve face. Then, using a valve lapper (available on the market), check the valve face-to-seat contact.
(2) The valve face contact area with the valve seat should be uniform and in the middle of the face. If not, reface with valve facer. (3) If the measured valve head margin (valve head thickness) is less than the limit, replace the valve. Unit: mm (in.) 10 0.5 mm (0.39 0.20 in.) Valve guide Cylinder head [15 mm] (0.59 in.) Valve guide protrusion above the cylinder head face Valve lapper Red lead Inspecting the valve face Good Bad Contact area (in the middle of the valve face) Valve seat-to-face contact Valve head sinkage Valve head margin Valve head sinkage 2 - 20 Standard value Limit Valve head margin 1.35 to 0.65 (0.0531 to 0.0650) 0.5 (0.0197)