ENGINE MAIN PARTS - INSPECTION AND CORRECTION 1.11 Lapping the valve face against the valve seat If the valve seat is corrected or the valve is replaced, be sure to lap the valve face against the valve seat in the following manner. (1) Apply a light coating of lapping compound evenly over the valve face. Note: (a) Take care not to allow lapping compound to attach to the valve stem. (b) Use medium lapping compound (120 to 150 mesh) first, then finish off with fine lapping compound (200 mesh or above). (c) Lapping compound spreads more evenly if it is mixed with a small amount of engine oil.
(2) Using a valve lapper, lap the valve face against the valve seat repeatedly while rotating it gradually. (3) Wash away the lapping compound in light oil or other similar liquid. (4) Apply engine oil onto the lapped faces and lap them again. (5) Check the lapped faces for correct contact. 1.12 Replacing the combustion jets Replace the combustion jets only when they are cracked or faulty. (1) To extract the combustion jet, insert a round rod with a diameter of approx. 6 mm (0.23 in.) into the glow plug mounting hole and gently tap the periphery of the combustion jet bore. (2) To install the jet, tap it into the mounting hole using a plastic hammer or other similar tool.
Ensure that the nozzle hole faces the center of the cylinder. Valve lapper Lapping compound Lapping the valve face against the valve seat Round rod Combustion jet Extracting the combustion jet 1 4 3 0 Combustion jet Tapping the combustion jet into place 2 - 22