Mitsubishi — Mitsubishi Diesel Engine Service Manual

ENGINE MAIN PARTS - INSPECTION AND CORRECTION 2. Flywheel, Timing Gear, Camshaft 2.1 Measuring the flywheel flatness Place the flywheel on a surface plate. Run a dial gauge over the frictional surface of the flywheel to measure the flatness. If the measured value exceeds the limit, grind the frictional surface. Unit: mm (in.) Measuring the flywheel flatness 2.2 Replacing the ring gear Check the ring gear for fractured or excessively worn gear teeth. If faulty, replace in the following manner. (1) Removing the ring gear (a) Using an acetylene torch or other similar equipment, heat the ring gear evenly.

(b) Using a hammer and a rod, tap the ring gear evenly on the entire periphery until the gear comes off. (2) Installing the ring gear Using a piston heater or other similar equipment, heat the ring gear [to approximately 150 (302 ° F ) or less]. With the gear warmed up, install it onto the flywheel with the un-chamfered side first. 2.3 Measuring the timing gear backlash Measure the backlash between the gears and use the measurements as references upon reassembly. If any of the measured values exceeds the limit, replace all gears unless otherwise specified. Unit:

mm (in.) Flywheel Ring gear Removing the ring gear Measuring the timing gear backlash 2 - 23 Standard value Limit Flywheel flatness 0.150 (0.0059) or less 0.50 (0.0197) Standard value Limit Timing gear backlash Crank gear - idler gear 0.040 to 0.120 (0.0015 to 0.0047) 0.300 (0.0120) Idler gear - valve camshaft gear Idler gear - pump camshaft gear Valve camshaft gear - PTO gear 0.080 to 0.190 (0.0032 to 0.0075) Pump camshaft gear - oil pump gear 0.070 to 0.200 (0.0028 to 0.0079)