Mitsubishi — Mitsubishi Diesel Engine Service Manual

ENGINE MAIN PARTS - INSPECTION AND CORRECTION 3.12 Measuring the cylinder bore Using a cylinder gauge, measure the cylinder bore and cylindricality. If any of the cylinders exceeds the limit, bore all cylinders of the same engine and replace the pistons and the piston rings with oversize parts. Measure at 3 locations as shown in the fig., each in directions A and B. Unit: mm (in.) Measuring direction A B Measuring location Measuring the cylinder bore 3.13 Measuring the cylinder block top face for distortion Using a straight edge across the top face of the cylinder block and a thickness gauge, measure for any distortion.

If the measured distortion exceeds the limit, correct by grinding the top face. Unit: mm (in.) Measuring location, Measuring direction Measuring the cylinder block top face for distortion The combined grinding limit for the cylinder block top face and the mating cylinder head bottom face is 0.2 mm (0.008 in.). 2 - 32 Pistons and piston rings available Cylinder bore Size Code Standard value Limit STD STD φ78+ 0. 03 0 (3.07+ 0.012) 0 Standard value +0.2 (0.0080) 0.25 OS 25 φ78.25+ 0. 03 0 (3.08+ 0.012) 0 0.50 OS 50 φ78.50+ 0. 03 0 (3.09+ 0.012) 0 Cylinder bore out of cylindricality ±0.01 (0.0004) max ― Standard value Limit Cylinder block top face distortion 0.05 (0.002) max 0.10 (0.004)