Mitsubishi — Mitsubishi Diesel Engine Service Manual

ENGINE MAIN PARTS - INSPECTION AND CORRECTION (a) If any of the crank journals need grinding, grind all crank journals on the same crankshaft to the same dimension. (b) Finish the fillets to a radius of 2.5 mm (0.098 in.). R2 mm (0.08 in.) R2 mm (0.08 in.) 3.9 Measuring the crankshaft for bend Support the crankshaft at the front and rear crank journals with a V block. Using a dial gauge, measure the center journal for a swing of the gauge needle (to both directions). If the measured value moderately exceeds the standard value, correct the bend by grinding. If the measured value far exceeds the standard value, correct the bend using a press or other similar equipment.

If the measured value exceeds the limit, replace the crankshaft. Unit: mm (in.) 3.10 Removing the crankshaft gear Use a gear puller to remove the crankshaft gear. Note: Do not remove the crankshaft gear unless the crankshaft or the gear is faulty. 3.11 Installing the crankshaft gear (1) Install the key to the crankshaft. (2) Align the keyway in the crankshaft gear with the key on the crankshaft, and press-fit the gear fully until it stops. Finished radius dimension of fillet Measuring the crankshaft bend Gear puller Removing the crankshaft gear Align these Installing the crankshaft gear 2 - 31 Standard value Limit Crankshaft bend 0.025 (0.0010) 0.050 (0.0020)