ENGINE MAIN PARTS - INSPECTION AND CORRECTION (a) If any of the crank pins need grinding, grind all crank pins on the same crankshaft to the same dimension. (b) Finish the fillets to a radius of 2 mm (0.08 in.). R2.5 mm (0.098 in.) 3.8 Inspecting the main bearings oil clearance (1) Place the main bearings (upper and lower) onto the cylinder block and the main bearing cap. Assemble them together and tighten the cap bolts to the specified torque. Measure the inner diameter of the main bearings. (2) Measure the diameter of the mating crank journal. The difference between the main bearings inner diameter and the crank journal diameter is the oil clearance for the main bearings. Unit:
mm (in.) Finished radius dimension of fillet Tightening torque 49.0 to 53.9 N m (5.0 to 5.5 kgf m) [36.2 to 39.8 lbf ft] Measuring direction Measuring location Measuring the main bearings inner diameter Measuring location Measuring direction (3) If the measured oil clearance exceeds the limit, replace the main bearings. With the new bearings installed, measure the oil clearance again. (4) If the measured oil clearance still exceeds the limit, use the undersize bearings [0.25 mm (0.0098 in.), 0.50 mm (0.0197 in.), 0.75 mm (0.0295 in.) U.S.] Also, grind the crank journal accordingly to the finished dimension shown below. Crank journal ground dimensions Unit:
mm (in.) Measuring the crank journal diameter 2 - 30 Nominal value Standard value Limit Crank journal diameter(STD) φ52 (2.0488) 51.985 to 52.000 (2.0482 to 2.0488) ― Oil clearance for main bearings ― 0.030 to 0.077 (0.0012 to 0.003) 0.100 (0.0040) Finished dimension Crank journal undersize 0.25 (0.0098) φ51.75 0 (2.0374 0 ) -0.015 -0.006 0.50 (0.0197) φ51.50 0 (2.0276 0 ) -0.015 -0.006 0.75 (0.0295) φ51.25 0 (2.0177 0 ) -0.015 -0.006