ENGINE MAIN PARTS - INSPECTION AND CORRECTION 3.6 Measuring the connecting rod end play Install the connecting rod and the rod cap onto the mating crank pin. Tighten the cap nuts to the specified torque. Using a thickness gauge, measure the gap (end play). If the measured value exceeds the limit, replace the connecting rod and the rod cap. Unit: mm (in.) 3.7 Inspecting the oil clearance for connecting rod bearings (1) Install the connecting rod bearings (upper and lower) into the connecting rod large end. Tighten the cap nuts to the specified torque. Measure the inner diameter of the bearings. (2) Measure the diameter of the mating crank pin.
The difference between the bearing inner diameter and the crank pin diameter is the oil clearance for the bearings. Unit: mm (in.) Thickness gauge Tightening torque 32.4 to 37.3 N m (3.3 to 3.8 kgf m) [23.9 to 27.5 lbf ft] Measuring the connecting rod end play Tightening torque 32.4 to 37.3 N m (3.3 to 3.8 kgf m) [23.9 to 27.5 lbf ft] Measuring direction Measuring location Measuring the connecting rod bearings inner diameter (3) If the measured oil clearance exceeds the limit, replace the bearings. With the new bearings installed, measure the oil clearance again.
(4) If the measured oil clearance still exceeds the limit, use the undersize bearings [0.25 mm (0.0098 in.), 0.50 mm (0.0197 in.), 0.75 mm (0.0295 in.) U.S.] Also, grind the crank pin accordingly to the finished dimension shown below. Crank pin ground dimensions Unit:
mm (in.) Measuring the crank pin diameter 2 - 29 Standard value Limit Connecting rod end play 0.10 to 0.35 (0.004 to 0.014) 0.50 (0.012) Nominal value Standard value Limit Crank pin diameter φ48 (1.8912) 47.950 to 47.964 (1.8892 to 1.8897) ― Oil clearance for connecting rod bearings ― 0.025 to 0.072 (0.0010 to 0.0028) 0.150 (0.0059) Measuring Measuring direction location Finished dimension Crank pin undersize 0.25 (0.0098) φ47.75-0.035 (1.881-0.0014) -0.050 -0.0020 0.50 (0.0197) φ47.50-0.035 (1.871-0.0014) -0.050 -0.0020 0.75 (0.0295) φ47.25-0.035 (1.861-0.0014) -0.050 -0.0020