ENGINE MAIN PARTS - INSPECTION AND CORRECTION 3.4 Measuring the clearance between the piston pin and the pin boss Measure the piston pin diameter. Measure the bore size of the piston pin boss. If the difference between them exceeds the limit, replace with new parts. Unit: mm (in.) Measuring direction Measuring location Measuring the piston pin-to-boss clearance 3.5 Measuring the connecting rod bend and twist (1) Measure C and l as illustrated. If measured C is more than 0.05 mm (0.0020 in.) per 100 mm (3.937 in.) of measured l , correct the connecting rod using a press. Unit:
mm (in.) C C 100 0.05 l l l Piston pin C C 100 0.05 l Connecting rod twist Connecting rod bend (2) Normally, a connecting rod aligner is used to measure the connecting rod for bend and twist. Note: Before measuring the connecting rod for bend, tighten the connecting rod cap nuts to the specified torque. (3) When measuring connecting rod bend with the piston installed to the connecting rod, place the piston/rod assembly on a surface plate such that the top of piston lies on the plate. Then, insert a round rod with the same diameter as the crank pin into the connecting rod large end. Using a dial gauge, measure the top of the round rod for any variation in height.
Measuring the connecting rod bend and twist Tightening torque for connecting rod cap nut 32.4 to 37.3 N m (3.3 to 3.8 kgf m) [23.9 to 27.5 lbf ft] Using a connecting rod aligner to measure the rod bend and twist D C A B Using a dial gauge to measure the connecting rod for bend 2 - 28 Nominal value Standard value Limit Piston pin diameter φ23 (0.9062) 22.944 to 23.000 (0.9039 to 0.9062) ― Piston pin-to-boss clearance ― 0.006 to 0.018 (0.0002 to 0.0007) 0.050 (0.002) Standard value Limit Connecting rod bend and twist 0.05/100 (0.002/3.940) or less 0.15/100 (0.006/3.940)