ENGINE MAIN PARTS - INSPECTION AND CORRECTION 3. Cylinder Block, Crankshaft, Pistons, Oil Pan 3.1 Measuring the piston diameter Using a micrometer, measure the piston diameter across the piston skirt and squarely with the piston pin, as illustrated. If the measured value is less than the limit, replace with a new part. The maximum allowable variation in weight among the pistons on the same engine is 5 grams (0.18 oz). Unit: mm (in.) Measure squarely with piston pin Measuring location Measuring the piston diameter 3.2 Measuring the clearance between the piston ring and the ring groove (1) Measure the piston ring-to-groove clearance.
If the measured value exceeds the limit, replace the piston ring. Unit: mm (in.) (2) With the new piston ring installed, measure the ring-to-groove clearance again. If the measured value still exceeds the limit, replace the piston. 3.3 Measuring the piston ring gap Install the piston ring being measured into the gauge or a new cylinder. Then, using a thickness gauge, measure the piston ring gap. If the measured value exceeds the limit, replace all rings of the relevant piston as a set. STD=78 +0.03 0 mm (3.07 +0.0012 0 in.) Gauge bore size 25 OS=78.25 +0.03 0 mm (3.08 +0.0012 0 in.) 50 OS=78.50 +0.03 0 mm (3.09 +0.0012 0 in.) No. 1 piston ring-to-groove clearance No.
2 piston ring-to-groove clearance Measuring the piston ring-to-groove clearance Thickness gauge Note: To install a piston ring into the gauge, use a piston to push the ring evenly. Unit: mm (in.) Measuring the piston ring gap 2 - 27 Nominal value Standard value Limit Piston diameter STD 78.00 (3.07) 77.93 to 77.95 (3.070 to 3.071) 77.80 (3.065) 0.25 OS 78.25 (3.08) 78.18 to 78.20 (3.080 to 3.081) 78.05 (3.075) 0.50 OS 78.50 (3.09) 78.43 to 78.45 (3.090 to 3.090) 78.30 (3.085) Max. allowable variation in weight among pistons on the same engine: 5 g (0.18 oz) or less ― Standard value Limit No. 1 ring 0.09 to 0.11 (0.0035 to 0.0043) 0.300 (0.012) No.
2 ring 0.07 to 0.11 (0.0028 to 0.0043) 0.200 (0.008) Oil ring 0.03 to 0.07 (0.0012 to 0.0028) 0.200 (0.008) Standard value Limit Piston ring gap No. 1 ring 0.15 to 0.30 (0.006 to 0.012) 1.50 (0.06) No. 2 ring 0.15 to 0.35 (0.006 to 0.014) Oil ring 0.20 to 0.40 (0.008 to 0.016)