ENGINE MAIN PARTS - REASSEMBLY 1. Cylinder Block, Crankshaft, Pistons, Oil Pan To reassembly, follow the disassembly sequence in reverse. 1.1 Installing the main bearings (1) Install the main bearings (upper and lower) onto the cylinder block and the main bearing cap, ensuring that the lugs engage with the lug grooves. (2) The flanged main bearings should be installed onto the No. 3 crank journal. (3) Lightly coat the inner surface of each bearing with engine oil. 1.2 Installing the crankshaft (1) Wash the crankshaft thoroughly in wash oil. Dry the crankshaft using compressed air. (2) While holding the crankshaft horizontally, lower it slowly onto the cylinder block.
(3) Lightly coat the crank journals with engine oil. 1.3 Installing the main bearing caps (1) Apply sealant onto the mating faces of the front and rear main bearing caps and the cylinder block. Installing the main bearings Installing the crankshaft (2) Install the main bearing caps so that their arrow marks point the front of the engine and that the cap numbers are in the order from the front to the rear of the engine. (3) Loosely tighten the cap retaining bolts. Correct installation of main bearing caps Install the front and rear main bearing caps so that they are flush with the cylinder block. Installing the main bearing cap 2 - 34 Sealant ThreeBond 1212