ENGINE MAIN PARTS - REASSEMBLY (4) Tighten the main bearing cap bolts progressively in diagonal sequence and tighten to the specified torque at the final step. (5) Ensure that the crankshaft rotates smoothly, without any binding. (6) Measure the crankshaft end play (refer to Page 2-14). If the measured value exceeds the limit, loosen and retighten the main bearing cap bolts. 1.4 Inserting the side seals (1) Apply sealant to the periphery of new side seals. Tightening torque:
49.0 to 53.9 N m (5.0 to 5.5 kgf m) [36.2 to 39.8 lbf ft] Tightening the main bearing cap bolts Ensure that the crankshaft rotates smoothly Side seal (2) With the seal radius faced outside, insert the side seals with your hand into the front and rear of the cylinder block. (3) Using a flat piece, push the last portion of the side seals fully into the cylinder block, taking care not to bend the seals. Radius Radius Face the side seals correctly Inserting the side seal 2 - 35 Sealant ThreeBond 1212