ENGINE MAIN PARTS - REASSEMBLY 1.5 Assembling the piston onto the connecting rod (1) Install the special tool Piston Pin Setting Tool onto a hydraulic press. (2) Place the connecting rod on the tool. Coat the connecting rod small end with engine oil. (3) Install the piston onto the connecting rod so that the arrow on the top face of the piston faces the side of the connecting rod that has the engine type embossed. Insert the piston pin slightly into the pin boss. (4) Using the push rod of the tool, press the piston pin into the pin boss.
Piston Pin Setting Tool Inserting the piston pin When the hydraulic press needle almost exceeds the 50 kgf (110.23 lbf) while the piston pin is being pressed, stop pressing the pin. Reset the push rod and start pressing again. (5) With the piston and the connecting rod assembled together, check that they slide smoothly about the piston pin. Inserting the piston pin with a hydraulic press Check that the piston and the connecting rod slide smoothly about the piston pin 2 - 36 Special tool Part number Piston Pin Setting Tool 31A91-00100