ENGINE MAIN PARTS - REASSEMBLY 1.6 Installing the piston rings Using the special tool Piston Ring Pliers, install the No. 1 ring, No. 2 ring, and oil ring onto the piston. Top face mark No. 1 compression ring No. 2 compression ring Note: (a) Install the rings so that “T” mark faces the top of the piston. (b) The oil ring should be installed so that the butt joint of the coil spring is located at 180 o relative to the ring gap as illustrated. 1.7 Installing the piston/connecting rod assemblies (1) Apply engine oil onto the periphery of the piston and the piston rings. (2) Position the piston ring gaps as illustrated.
The gaps should not face the same direction as the piston pin or squarely with the piston pin (3) Install the connecting rod bearing (upper) onto the connecting rod, ensuring that the lug engages with the lug groove. (4) Rotate the crankshaft until the crank pin onto which the piston/connecting rod assembly is being installed comes to the top dead center. (5) Face the piston/connecting rod assembly so that the arrow mark on top of the piston points to the timing gear case side (front) of the engine. (6) Using a piston guide (available on the market), insert the piston/connecting rod assembly from the top of the cylinder block down.
Oil ring Piston ring arrangement Coil spring butt joint 180 Oil ring gap Assembling the oil ring Oil ring gap Front of engine No. 1 ring gap No. 2 ring coil spring butt joint Locating the piston ring gaps Do not tap the piston too hard. Doing so may break the piston rings or damage the crank pin. Piston guide Installing the piston/connecting rod assembly 2 - 37 Special tool Part number Piston Ring Pliers 31391-12900