Mitsubishi — Mitsubishi Diesel Engine Service Manual

ENGINE MAIN PARTS - REASSEMBLY 1.8 Installing the connecting rod caps (1) While pressing the top of piston down to keep the connecting rod large end attached to the crank pin, rotate the crankshaft 180°. (2) Install the connecting rod bearing (lower) onto the connecting rod cap, ensuring that the lug engages with the lug groove. (3) Install the bearing cap onto the connecting rod, observing the mating marks made during disassembly. Note: If a new connecting rod without mating marks is being installed, ensure that the lug grooves, designed to prevent the bearings from turning, are assembled on the same side.

(4) Tighten the connecting rod cap nuts alternately in several steps, and finally to the specified torque. (5) Check the connecting rod end play. 1.9 Installing the oil strainer (1) Position the cylinder block with the oil pan mounting face up. (2) Install the oil strainer so that the tip of the strainer will not contact the oil pan when installed. Tighten the nut to the specified torque. 1.10 Installing the oil pan (1) Clean the mating faces of the cylinder block and the oil pan. Apply sealant to the entire periphery of the oil pan mounting face of the cylinder block. Lug groove Cylinder No. Installing the connecting rod cap Tightening torque:

32.4 to 37.3 N m (3.3 to 3.8 kgf m) [23.9 to 27.5 lbf ft] Tightening the connecting rod cap nuts Tightening torque: 24.5 to 29.4 N m (2.5 to 3.0 kgf m) [18.1 to 21.7 lbf ft] Installing the oil strainer Applying sealant to the oil pan mounting face of the cylinder block 2 - 38 Sealant ThreeBond 1207C