Kaiyi HL940 — Kaiyi HL940 User Manual

2) DISASSEMBLY AND ASSEMBLY DISASSEMBLY AND ASSEMBLY (1) ц PUSH BUTTON PUSH BUTTON The remote control valve does not need to be removed from the machine to perform this operation. Remove worn pushbutton using a small screwdriver. The installation of new elements is performed without any special tools; the parts are simply pressed into place. (2) RUBBER BOOT RUBBER BOOT Remove the remote control valve from the machine or free the valve by unscrewing the 4 screws fixing the plate in order to release the electrical cable. В Assembly Torque : 1.02 kgf В m (7.4 lbf В ft ) Hold the remote control valve using a vice or a vice-grip wrench (clamp onto the body).

Η ц The pilot unit does not need to be removed from the machine to release the cable. However, it is recommended to lift the control unit by undoing the 4 fixing screws on the arm rest. It is unnecessary to remove the units with no electrical functions. ц Lift and turn the boot inside out. Remove the grommet (7) from its emplacement to free the cable. Loosen the handle mounting nut (3-3) using a 19 mm open-end wrench. В Assembly : torque 4.08 kgf В m (29.5 lbf В ft ) Unscrew and remove the handle (1). В Assembly - Add loctite 262 onto the lever thread - Torque : 4.08 kgf В m (29.5 lbf В ft ) Replace the faulty rubber boot (4) with a new one.

Replace the handle (1) following the disassembly instructions in reverse order. Θ Ι Κ Λ Μ Ν (3) HANDLE HANDLE Clamp the threaded section of the lever (3-2) in a vice fitted with V-shaped vice clamp. Remove the pin (3-1) using a 5 mm pin driver. Replace the lever (3-2) onto the new handle (1) and secure it with the pin (3-1) using a 5 mm pin driver. Η Θ Ι ц Respect the position of the curved lever to ensure that the handle is correctly oriented as indicated by the machine’s technical specifications. Κ Replace the nut (3-3) on the threaded section and replace the boot (4). 6-86