Kaiyi HL940 — Kaiyi HL940 User Manual

(4) DETENT CARDAN BRACKET KIT DETENT CARDAN BRACKET KIT Remove the 2 grommets (20-1) from the flange (20). Place centering sleeves V & W to avoid damaging the cardan knuckles while loosening the nuts. Unscrew the locking nut (5) using a 23mm open-end wrench. В Assembly : Torque 4.08 Ь 0.4 kgf В m ц W ц V ц (29.5 Ь 2.9 lb G ·ft ) Before loosening the nuts Unscrew the self-locking nut (11-1) using a 13 mm open-end wrench. В Assembly - Torque 1.02 kgf В m (7.4 lbf В ft ) - Place centering sleeves (V-W) to avoid damaging the cardan knuckles while screwing the nuts. Remove :

- Friction washer (11-2) - Friction washer (11-3) - Cardan/armature assembly (11-4 ~ 11-6) Η W V Θ After removing the cardan bracket 7707WE65 (5) NON-DETENT PLUNGER KIT NON-DETENT PLUNGER KIT Unscrew the self-locking nut (12-1) using a 13 mm open-end wrench. В Reassembly : - Torque 1.02 kgf В m (7.4 lbf В ft ) Η - Place centering sleeves (V-W) to avoid damaging the cardan knuckles while screwing the nuts. Undo the snap ring (12-2) using a flat-end screwdriver. Remove the screw assembly (12-3, 12-4) Θ Ι (6) CARDAN CARDAN Remove the centering sleeves V & W. Remove the cardan bracket (10) and the shims (14). Unscrew the cardan (15) using a 17 mm open-end wrench. В Reassembly :

- Ungrease the cardan threads - Add loctite 262 onto the cardan threads (both end) - Torque 4.08 kgf В m (29.5 lbf В ft ) Η Θ Ι (7) SOLENOID AND CONNECTOR SOLENOID AND CONNECTOR It is advised to mount the connector onto the solenoid cable once the remote control valve is assembled. ц Η Θ Ι Κ ц Λ Remove the flange (20) and the electrical bracket (25), Remove the protecting bushes (26) from the electrical bracket (25). Undo the solenoid (21) from the electric bracket (25). Replace the solenoid. Clean the polar face using a piece of cloth and pay attention not to hit them. Assembly : Place the solenoid cable in its emplacement on the electric bracket before fitting the protection bushes. 6-87