Komatsu — OVERLOAD WARNING DEVICE

OPERATION OPERATION CHECK AFTER STOPPING ENGINE 1. Walk around the machine and check the work equipment, paint work, and undercarriage, and check also for leakage of oil or water. If any abnormalities are found, repair them. 2. Fill the fuel tank. 3. Check the engine compartment for paper and debris. Clean out any paper and debris to avoid a fire hazard. 4. Remove any mud stuck to the undercarriage. LOCKING Always lock the following places. REMARK Use the starting switch key to open and close all these places. OVERLOAD WARNING DEVICE Excavators are provided with this device to warn the operator about tipping over while lifting loads. A buzzer will sound when the machine is in LO mode.

and the machine nears its lifting capacity NOTE: Only conduct lifting operations in LO mode as the over- load warning system is only active in this mode. 141 (1) Door of operator’s cab. Always remember to close the window. (2) Fuel tank filler port (3) Engine hood (4) Tool box cover (5) Battery room door (left side of machine)