Komatsu — HANDLING THE WHEELS

OPERATION OPERATION HANDLING THE WHEELS Incorrect handling of wheels and tyres can result in serious injury or death. Particular care is required when working on twin wheel assemblies. Before any attempt is made to remove the road wheels the tyres must be fully deflated. 1. General information Always replace damaged parts with new parts from your Komatsu distributor. Never attempt to repair damaged items. Use the appropriate tools in a good condition to remove the various pieces of the rim. Never use metallic hammer, use a mallet with a face made from Rubber, Plastic or Copper.

On machines fitted with twin wheel assemblies a valve exten- sion is fitted to the inner wheel to facilitate deflation. This part should always be refitted following disassembly as it ensures that the inner wheel assembly can be deflated whilst fitted to the hub. 2. Before starting to remove the wheels 1. Depress the brake pedal fully until it locks. 2. Raise the chassis with the boom so that the tyres are raised above the ground. Then, place axle stands below the front and rear axles. 3. Loosen wheel nuts with a wheel wrench. Wheel nuts have R.H. threads. 4.

Proceed in accordance with the following procedure, paying attention to the information specific to the type of wheel assembly fitted to the machine on which you are working. 142 WARNING Tyre pressure: 10.00 - 20 14 ply tyres (Twin assy) Front wheel: 6.75 Bar Rear wheel: 6.75 Bar Tyre pressure: 18 R 19.5 (Single) Tyres Front wheel: 8.0 Bar Rear wheel: 8.0 Bar