MAINTENANCE. SERVICE PROCEDURE REPLACE BUCKET TEETH Replace the teeth before the wear reaches the adaptor. It is dangerous if the work equipment moves by mistake when the teeth are being replaced. Set the work equipment in a stable condition, then stop the engine and apply the control lever pad safety lock. NOTICE Please confirm with your bucket supplier for the correct pro- cedure to replace bucket teeth and side cutters. ADJUST BUCKET CLEARANCE It is dangerous if the work equipment moves by mistake when the clearance is being adjusted. Set the work equipment in a stable condition, then stop the engine and lock control lever pad safety lock. 1.
Set the work equipment to the position shown in the diagram at right, stop the engine and set the safety lock lever to the lock position. 2. Shift 0-ring (1) of the linkage and measure the amount of play (a). Measurement is easier if you move the bucket to one side or the other so all the play can be measured in one place. (In the diagram this is on the left-hand side) Use a gap (clearance) gauge for easy and accurate measure- ment. 3. Loosen the four plate fixing bolts of (2) and loosen plate (3). Because it uses split shims, you can carry out the operation without removing the bolts entirely. 201 WARNING WARNING