Komatsu — CHECK AND ADJUST AIR CONDITIONER

SERVICE PROCEDURE MAINTENANCE. 4. Remove shim (4) corresponding to the amount of play (a) measured above. [Example] If the play is 3 mm, remove two sets of 1.0 mm shim (4 pieces) and 0.5 mm (2 pieces) and the play will become 0.5 mm. Four sets of 1.0 mm (8 pieces), two sets of 0.5 mm (4 pieces) are installed. Two pieces of shim makes one set. When play (a) is smaller than one shim, do not carry out any maintenance. 5. Tighten the four bolts (2). If the bolts (2) are too stiff to tighten, pull out pin stopper bolt (5) for easier tightening. CHECK WINDOW WASHER FLUID LEVEL, ADD FLUID If air is ejected with the window washer fluid, check the fluid level in window washer tank (1).

If showing under the level, fill with automobile window washer fluid. When adding fluid, be careful not to let dirt or dust get in. Mixture ratio of pure washer fluid and water Since the ratio should be varied depending on atmospheric temperature, replenish washer fluid at the following mixture ratio, taking temperature into account. Pure washer fluid comes in two types: for -10°C (for general use) and for -30°C (cold regions). Use pure washer fluid according to operation area and season.

CHECK AND ADJUST AIR CONDITIONER CHECK LEVEL OF REFRIGERANT (GAS) If the liquid get into your eyes or on your hands, it may cause loss of sight or frostbite, so never loosen any part of the refrigerant circuit. The air conditioning system is equipped with pressure switches which disable the system if the pressure is too high or low, to pre- vent damage to the system. If the air conditioner fails to operate it may be due to: 202 Operation area and season Mixture ratio Freezing temperature Normal Pure washer 1/3: water 2/3 fluid - 10° C Winter in cold region Pure washer fluid 1/2: water 1/2 - 20°C Winter in extremely cold region Pure washer fluid - 30°C WARNING