Komatsu — CHANGE OIL IN HYDRAULIC TANK

SERVICE PROCEDURE MAINTENANCE. 2. Retract the arm and bucket cylinders to the stroke end, then lower the boom and put the bucket teeth in contact with the ground. 3. Lock the control lever pad safety lock lever and stop the engine. 4. Remove the cover over the hydraulic tank and remove the cap of oil filler (F). 5. Set the oil container under the drain plug under the machine. Using the handle, remove drain plug (P) and drain the oil. Check the O-ring installed to plug (P), and if it is.damaged, replace the O-ring. After draining the oil, tighten drain plug (P). Tightening torque: 69 ± 10 Nm (7 ± 1 kgm). When removing drain plug (P), be careful not to get oil on your- self. 6.

Add the specified amount of engine oil through oil filler port (F) Check that the oil level is between H and L on the sight gauge. For type of oil to be used, see “USE FUEL, COOLANT AND LUBRICANTS ACCORDING TO AMBIENT TEMPER- ATURE” on page 177. NOTICE When the hydraulic breaker is installed, the hydraulic oil deteriorates earlier than in normal bucket digging work. Therefore replace the hydraulic oil according to the table at the right. Replacement interval (H) Replacement interval for hydraulic oil 7. After replacing hydraulic oil or replacing filter element and strainer, bleed air from the circuit according to the following procedure.

(When not using breaker) Breaker operation (ratio %) Hydraulic Fillerelement AD31373D (When using breaker only 232