Komatsu — CHANGE OIL IN HYDRAULIC TANK

MAINTENANCE. SERVICE PROCEDURE Procedure for bleeding air Follow steps 1 to 7 to bleed the air. 1. Bleeding air from pump 1. Loosen air bleeder (1) installed to the drain port, and check that oil oozes out. (Completion of air bleeding) 2. After completing the air bleeding operation, tighten the air bleeder. NOTE: If the pump is operated without filling the pump case with hydraulic oil, abnormal heat will be generated and this may lead to premature damage of the pump. 2. Starting engine Start the engine according to “STARTING ENGINE” on page 113 keep running the engine at low idling for 10 minutes, and carry out the following procedure. 3. Bleeding air from cylinders 1.

Run the engine at low idling, and extend and retract each cyl- inder 4 - 5 times without operating it to the end of its stroke. (Stop approx. 100 mm before the end of the stroke) 2. Next, operate each cylinder to the end of its stroke 3 - 4 times. 3. After this, operate each cylinder 4 - 5 times to the end of its stroke to completely bleed the air. NOTICE If, at first, the engine is run at high speed or the cylinder is operated to the end of its stroke, the air inside the cylinder may cause damage to the piston packing or other parts. 4. Bleeding air from swing motor (only after draining oil from swing motor case) 1.

Run the engine at low idling, loosen air bleeding plug (1), and check that oil oozes out from air bleeding plug (1). NOTICE When doing this, do not operate the swing· 2. If oil does not ooze out, stop the engine, remove air bleeding plug (1), fill the motor case with hydraulic oil. 3. After completion of the air bleed operation, tighten air bleed- ing plug (1). 4. Run the engine at low idling, and swing 2 or more times slowly and uniformly to the left and right. NOTICE If the air is not bled from the swing motor, the bearings of the motor may be damaged. 233