AIR CLEANERS AND FUEL SYSTEM-N.10 ATOMISERS ::4------1 General When replacing atomisers in the cylinder head, it is essential that a new, correct type copper washer is fitted between the nozzle body and cylinder head, The correct torque for the atomiser securing nuts is 12 Ibf It (1,7 kgf m) or 16 Nm, The first symptoms of atomiser, trouble usually come under one or more of the following headings:- ....... -----2 2, Knocking in one (or more) cylinders, Misfiring, 3, Engine overheating, [!!ooIII~----5 4, Loss of power, 5, Smoky exhaust (black), 6, Increased fuel consumption, Testing for Faulty Atomiser If an atomiser is suspected of being faulty, try this method to isolate it.
Slacken the union nut at the atomiser end of the high pressure fuel pipe, If each atomiser is isolated in turn in this way, (with the engine running at approxi- mately 1,000 rev/min) tightening each union nut firmly before proceeding to the next, then the faulty atomiser, when isolated in this manner, will have little or no effect on the running, 10 Warning Great care should be taken to prevent the hands or face from getting into contact with the spray, as the working pressure will cause the oil to penetrate the skin with ease, .......------11 Atomiser Pressures ....... ----12 Details of holders and nozzle types together with pressure settings are given on Page 8,12, ~ ...
13 NO ATTEMPT SHOULD BE MADE TO ADJUST THE INJECTION PRESSURE WITHOUT AN ATOMISER TESTING PUMP, IT IS QUITE IMPOSSIBLE TO ADJUST THE SETTING OF ATOMISERS WITH ANY DEGREE OF ACCURACY WITHOUT PROPER EQUIPMENT. 1. 2, 3, 4, 5, 6, 7, 8, 9. 1O, 11, 12, 13, Capnut N20 Spring cap Shim washer Nozzle spring Identification tab washer Spindle Fuel inlet union Nozzle holder body Securing flange Nozzle needle Nozzle body Nozzle capnut Copper sealing washer Atomiser Identification Atomisers can be identified by code letters stamped on a tab washer fitted under the spring cap nut (see Fig, N,20) or alternatively, the code is stamped on the atomiser body, Details of codings can be found on Page 8,12,