Perkins — Perkins 4.108 4.107 4.99 Diesel Engine Workshop Manual

SECTION P Flywheel and Flywheel Housing To Remove the Flywheel 1. Remove the gearbox, clutch assembly and any linkage as detailed in the service literature applic- able to the particular vehicle or application. 2. Knock back the locking tabs from the flywheel securing setscrews. 3. Remove the securing setscrews and carefully re- move the flywheel from the crankshaft flange. To Renew the Flywheel Ring Gear 1. The flywheel ring gear is a shrunk fit on the fly- wheel, its removal is carried out by partially cut- ting through the gear and chisel cutting it from the flywheel.

An alternative method is to apply localised heat to the ring gear to expand it sufficiently to enable it to be tapped evenly from the flywheel. 2. The locating faces of the flywheel should be thoroughly cleaned to ensure a positive location when the new ring gear is fitted. 3. Clean, then heat the new ring gear to a tempera- ture not exceeding 480°F (250 P1 Q C). 4. Fit the ring gear over the flywheel with the lead on the teeth facing uppermost, i.e., facing away from the engine when the flywheel is fitted. Rotate the gear quickly on its location immediately it is fitted to ensure it is laying flat, then allow to cool. 3.

Set up a dial test indicator (clock) gauge with the base secured against the rear face of the flywheel housing and the gauge stylus at right angles to the periphery of the flywheel. Turn the crankshaft and check the run out, the flywheel should run truly within 0.012 in (0,30 mm) total indicator reading To Refit the 1"1",.11' .. "" .. 1 It is most essential to ensure that the crankshaft flange face and periphery are perfectly clean and free from burrs, similarly the mating face of the flywheel itself before refitting of the flywheel is attempted. Failure to ensure this may make it impossible to fit the flywheel satisfactory within the various limits quoted hereafter.

It will be noted that there is a sixth (untapped) hole in the crankshaft flange which will be at B.D.C. when Nos. 1 and 4 pistons are at T.O.C. The flywheel can only be fitted in one position due to the irregular spacing 01 the setscrew holes. 1. It is advisable to screw a short stud into the crank- shaft flange just finger tight, so that when the fly- wheel is offered up this stud can take the weight of the flywheel whilst the securing setscrews are fitted, this stud can then be removed and re- placed by the fifth setscrew. 2. Tighten the securing setscrews to the torque given on Page B.2 but do not lock with the tab washers at this stage. P2