FLYWHEEL AND FLYWHEEL HOUSING-P.2 4. Carefully examine the housing for any signs of cracks, fretting or other damage. To Refit the Flywheel Housing 1. Ensure that the rear face of the cylinder block and the mating face of the flywheel housing are perfectly clean and free from burrs, etc. 2. Locate the flywheel nousing carefully on the two dowels and refit the securing setscrews. 3. Mount a dial test indicator (clock) gauge with the base on the crankshaft flange and the gauge stylus on and perpendicular with the inner face of the housing aperture as shown in Fig. P.2.
Rotate the crankshaft, the inner bore should be truly central with the crankshaft within the limits listed towards the end of this section. 4. With the gauge base still mounted in the same position adjust the stylus so that it is at right angles to the vertically machined rear face of the flywheel housing as shown in Fig. P.3. Turn the crankshaft and check that this face is at right angles to the cranshaft axis to within the follow- ing limits. Check dowel location in block and housing, ream and fit oversize dowels where necessary. P3 Diameter of Max.
Housing Bore Allowance (total indicator reading) Up to 14{ in 0.006 in (0,15 mm) (362 mm) 141 to 201 in 0.008 in (0,20 mm) (362 to 511 mm) 201. ot 25! in 0.010 in (0,25 mm) (511 to 648 mm) 25! to 31 in 0.012 in (0;30 mm) (648 to 787 mm) 4. Check the alignment of the flywheel face by posi- tioning the gauge as shown in Fig. P.1. Turn the crankshaft and the total indicator reading for the flywheel being truly at right angles to the crank- shaft axis should not exceed 0.001 in (0,025 mm) for every inch (25 mm) the gauge stylus is reading from the centre of the flywheel, i.e. if the flywheel has a diameter of approx. 20 in (500 mm) then the stylus will be approx.
10 in (250 mm) from its centre, therefore the total indicator reading should not exceed 0.010 in (0,25 mm). 5. When the flywheel is correctly aligned, lock the securing setscrews with the tabwashers. NOTE: Any adjustments which may be necessary to bring the flywheel housing within the limits quoted must be carried out on the housing, under no circumstances may the rear face of the cylinder block be interferred with. To Remove the Flywheel Housing 1. Remove the flywheel (Refer to previous text). 2. Remove the starter motor. 3. Unscrew the securing setscrews and carefully tap the housing clear of the locating dowels. 5.
When the housing is correctly aligned finally tighten the securing setscrews. 6. Refit the flywheel as previously discribed on Page P.i.