Perkins — Perkins 4.108 4.107 4.99 Diesel Engine Workshop Manual

ELECTRICAL EQUIPMENT -Q.9 CHECKING GLOW PLUGS To Check for Continuity of Glow Plugs (a) Remove leads from glow plugs. (b) Connect test lamp (A) as shown, to live (+ VEl terminal. Positive Term. of Battery .."y" or other supply (c) Check operation of lamp by earthing end (X) to engine head . (d) Connect test point "X" to each glow plug terminal in turn, lamp will light on 'good' glow plugs and will not light on open circuit (faulty) glow plugs. 'A' Test Lamp with 12v. Automotive lamp of low wattage.l6w.) x To Check Supply to Glow Plugs Connect test lamp (B) between point 'd' and earth (engine mass). When heater switch is operated the lamp should light.

From 'Heater' Switch 'B'®-~II' Engine Mass Checking Glow Plus Using a Voltmeter 1. Disconnect glow plug interconnecting links and main feed wire. Glow Plugs Where glow plugs are used as a starting aid, the bus bar connecting the four plugs is electrically energised when the equipment is used. 2. To check each glow plug individually connect a 30-0-30 ammeter in series with main feed cable and glow plug terminal. As this bus bar is not insulated, extreme care must be exercised in as much as all pipes, clips and other metal objects must be kept well clear. 3. Connect a 0-20 voltmeter from Glow Plug terminal to earth.

The consequences of a direct short of this bus bar to earth when energised are obvious. 4. Press heater button and observe ammeter and voltmeter readings. A current of about 9 amps will be seen when the voltage is in the region of 11 to 12 volts. Energise plugs for about 20 to 30 seconds. On early engines the glow plugs are screwed into adaptors which are fitted to the cylinder head. On later engines the adaptors are removed and glow plugs are screwed directly into the cylinder head. The latest engines have the holes in the cylinder head for the tip of the glow plugs increased to accept glow plugs with a larger tip diameter. 5. If the reading is low, or non existent, plug should be replaced.

6. If no volt-meter reading is observed, a defective feed cable or switch is the probable cause. 4.108 Series Workshop Manual, June 1986