Komatsu — COLD WEATHER OPERATION

A: STARTING IN COLD WEATHER For the pre- and post-starting inspection, refer to the section OPERATING YOUR MACHINE. Set fuel control dial (1) at the low idling (MIN) position. (a): Low idling Turn the key of starting switch (2) to HEAT, and confirm that engine pre- heating monitor lamp (3) comes on. After about 30 seconds, preheating monitor lamp (3) will flash for about 10 seconds to indicate that preheat- ing is finished. After preheating monitor lamp (3) starts to flash, turn the key of starting switch (2) to START and start the engine. When the engine starts, return the key of starting switch (2) to the ON position.

(The key will return automatically when released.) If the engine does not start up under the above procedure, repeat steps 2 and 3 after waiting for about 2 minutes. A Never use starting aid fluids as they may cause explosions. - 102-