Mack Trucks — PV776-21394653.pdf

Operator’s Manual Vehicle Maintenance CXU, CHU, GU, TD, MRU and LEU 139 Lubrication Notes 1 Spring hanger: Use a lithium based grease with specification API NLGI No. 2. When lubricating the left and right sides of the front springs, lift the axle off of the floor, suspend the frame with axle stands and lower the axle. The spring bushings are now in the position where grease can be added to the contact surfaces. Note: The rock guard will have to be removed (if equipped). Note: Always grease a MACK front axle with the wheels on the ground. Note: To grease non-MACK axles, they are typically greased with the wheels on the ground. Consult with the axle manufacturer for the latest recommendation.

6 Tie-rod: Use a lithium based grease with specification API NLGI No. 2. Note: MACK axles may use a greased-for-life tie-rod. No provisions for adding grease are available. Note: Always grease a MACK front axle with the wheels on the ground. Note: To grease non-MACK axles, they are typically greased with the wheels on the ground. Consult with the axle manufacturer for the latest recommendation. 2 Slack adjuster: Do not grease till 1st scheduled maintenance interval. 7 Leaf Springs: Front and rear leaf spring eye pins, should be pressure lubricated with chassis grease.

Vehicles equipped with multi leaf springs should also have, the leaves lubricated with a spray gun or brush using a rust inhibiting oil. Note: See Manufactures Specifications for specific grease. Adjust according to the specific slack adjuster manufacturing specifications. 2A Brake cam: CAUTION Note: If the brake cam seal does not purge, make sure the inner seal does not purge into the brake drum and onto the brake linings. 3 Steering gear: Use a lithium based grease with specification API NLGI No. 2. Only use a hand operated grease gun. The high pressure from an air operated grease gun will damage the seal. 4 Draglink and Steering Shaft:

Use a lithium based grease with specification API NLGI No. 2. 5 Kingpin, upper and lower: Use a lithium based grease with specification API NLGI No. 2. Keep grease and oil, off of rubber bushings. Failure to do so will result in component damage. Note: If the vehicle is operated in sandy or dusty environments, the spring ends should be left dry. Dirt and grease can mix, resulting in a "sandpaper" action that may cause pre-mature wear to the spring ends. 8 Brake fluid and clutch reservoir: Check the fluid level in the reservoir. Add brake fluid if necessary. Use only DOT 4 brake fluid in the clutch release system.

Mixing DOT 4 brake fluid with petroleum based oil will cause seal damage which will cause leakage.