Mack Trucks — PV776-21394653.pdf

140 Operator’s Manual Vehicle Maintenance CXU, CHU, GU, TD, MRU and LEU 9 Clutch bearing linkage: Use a lithium based grease with EP additives to specification API NLGI No. 2. on the hub or if dirt is found in the lubrication. Use motor oil SAE 30. Lubricate both the right and the left wheel bearings. Note: Inspection cover removal is necessary. Lubricate according to Eaton’s lubrication document and reinstall the inspection cover. See http://www.roadranger.com for the latest heavy-duty clutch service information. 16 Power steering fluid: Check the fluid in the reservoir with the dipstick. Add oil if necessary. Use ATF Dexron® III or better. Change fluid every 150,000 miles (240,000 km).

Change filter every year. Use a lithium based grease with specification API NLGI No. 2. 10 U-Joints: Use a lithium based grease with EP additives to specification API NLGI No. 2. 17 Engine oil and filter: For oil change schedule see Service Information in Group 175-60. Note: Ensure that grease purges out of all four seals of the U-joints. 18 Windshield washer fluid level. 11 PTO/Hydraulic reservoir. 19 Automatic and manual transmission: Automatic transmission: Use Dexron® III or better Automatic Transmission fluid. See the manufacturer’s Operator’s Manual for intervals and quantity. Manual transmission: Use a mineral or synthetic oil. Check oil level periodically.

Level should be to the bottom of the inspection hole. M-Drive transmission: With the vehicle level, the oil should be between the maximum and minimum levels on the sight glass. Only use MACK approved oils. Refer to function group 1 for the approved oils list. 12 Rear Suspension (48k-70k suspension): When lubricating the spring pin busing use a lithium based grease with specification API NLGI No. 2. Note: Newer versions may have rubber bushing that do not need lubrication. Note: Earlier versions of the T-Ride and B-Ride spring cradle required lubrication. 13 Coolant level: Add coolant if necessary. Only use pre-mixed clean water and antifreeze in a 50/50 mix.

Add only the same type antifreeze, that is: extended life or standard. 14 Steering assist cylinder: Use a lithium based grease with EP additives to specification API NLGI No. 2 to grease both ball joints. 20 Auxiliary axle(s): If equipped with auxiliary lift axles use a lithium based grease with specification API NLGI No. 2. Also, lubricate the Brake, Cams, Slack adjuster and Tie-rod ends. 15 Front oil lubricated wheel bearings (if applicable): There is no set change interval. Change the oil (or grease) only in connection with work 21 Rear axle: Check the oil level in the differential by removing the fill/level